Preparation; Attaching The Stand Unit - Sharp AQUOS LC-70UX500H User Manual

Preparation

Attaching the stand unit

• When you attach the stand unit, put the TV on a flat surface.
• Before attaching (or detaching) the stand unit, unplug the AC power cord from the AC power outlet.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it
from being damaged.
CAUTION
• Attach the stand unit in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand unit may result in the TV falling over.
As shown in the following figure,take out the foam
1
blocks TOP-L,TOP-R,and put it on the flat floor.
Insert the supporting post into the foam block,
and then attach the stand onto the supporting
post.
"R"
supporting post
TOP-L
Insert six long screws into the six holes on
2
the bottom of the stand, and tighten them.
• To install the stand correctly, hold the stand with
one hand securely, and tighten the screws with
the other hand.
Place the TV on a flat surface with soft cushion
3
on top of it. Insert the stand unit into the slot
on the bottom of the TV while holding the
stand unit to avoid it falling over.
soft cushion
4
"L"
supporting post
TOP-R
• When installing the stand unit, you need to put your TV on a
flat
• To detach the stand unit, perform the steps in reverse
order.
• The angle of the stand unit is not adjustable.
• A screwdriver is not supplied with this product.
• During installation, please be careful to avoid getting your
hand trapped between the TV bottom and the floor.
Insert the rest of four short screws into the four
holes on the back of TV, and tighten them.
short screws
NOTE
surface. Before that, put a soft cushion on the surface.
9