Table of Contents
Advertisement
3.1
Tools
To set up the wheelchair the following tools are needed.
•
Wrench set n° 10 to n° 19
•
Allen key set n° 4 to n° 5
•
Screwdriver Phillips head
3.2
Manner of delivery
The Vermeiren 28 shall be delivered with:
•
1 frame with armrests, rear and front wheels (seat height of 500 mm, seat angle of
5° )
•
1 pair footrests
•
Back and seat cushion
•
Tools
•
Manual
•
Accessories (optional)
•
Pump (with pneumatic tyres only)
Before use check if everything is included and that no products are damaged (example by
transport, ...).
3.3
Anatomical seat (OPTIONAL)
L L L L
WARNING:
Risk of injury – Check that the seat is secured before use.
L L L L
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
3.4
Anatomical backrest (OPTIONAL)
L L L L
WARNING:
Risk of injury – Check that the backrest is secured before use.
L L L L
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
If you have opted for an anatomical padded seat, place it on
the tubular cross-hinge so that the seat's supports engage
equally with the cross-hinge. In the wooden base you will find
slots that are placed in the hinge's cross-pieces. To fold up the
wheelchair, remove the seat by pulling it upwards.
To use the anatomical backrest, proceed as follows:
1. Unscrew the flexible backrest.
2. Loosely screw on the brackets for the backrest.
3. Insert the backrest into the brackets from above.
4. Tighten the screws holding the brackets for the
backrest.
5. Insert and tighten the safety screws for the
backrest.
6. Add the arm supports.
Page 13
28
2012-04
Advertisement
Table of Contents
