Btu Specifications; Non-Combustible Materials Specification; Combustible Materials Specification; Electrical Codes - Harman P43 Installation Manual

D. BTU & Efficiency Specifications
P43 Freestanding Pellet Stove:
Particulate

Emissions Rating:
*BTU Output:
Heating Capacity:
Hopper Capacity:
Fuel:
Shipping weight:
P61A Freestanding Pellet Stove:
Particulate
Emissions Rating:
*BTU Output:
Heating Capacity:
Hopper Capacity:
Fuel:
Shipping weight:
P68 Freestanding Pellet Stove:
Particulate
Emissions Rating:
*BTU Output:
Heating Capacity:
Hopper Capacity:
Fuel:
Shipping weight:
*BTU output will vary, depending on the brand of fuel you use in
your appliance. Consult your Harman® dealer for best results.
5
Average Emissions - 1.4 g/h
12,631 - 32,163 / hr
up to 2,400 sq. ft. depending on
climate zone
50 lbs
Wood Pellets or Shelled Corn
212 lbs
N/A
0 - 61,000 / hr
up to 3,500 sq. ft. depending on
climate zone
72 lbs
Wood Pellets or Shelled Corn
249 lbs
N/A
0 - 68,000 / hr
up to 3,900 sq. ft. depending on
climate zone
76 lbs
Wood Pellets or Shelled Corn
290 lbs
Harman® • P-Series Installation Manual_R3 • 2014 -___ • 09/14
E. Non-Combustible Materials Specification
Material which will not ignite and burn. Such materials are
those consisting entirely of steel, iron, brick, tile, concrete,
slate, glass or plasters, or any combination thereof.
Materials that are reported as passing ASTM E 136,
Standard Test Method for Behavior of Materials in
a Vertical Tube Furnace at 750° C and UL763 shall be
considered non-combustible materials.
F. Combustible Materials Specification
Materials made of or surfaced with wood, compressed
paper, plant fibers, plastics, or other material that can ignite
and burn, whether flame proofed or not, or plastered or un-
plastered shall be considered combustible materials.
G. Electrical Codes
120 VAC, 60 Hz, Start 4.2 Amps, Run 2.8 Amps
NOTE: Some generator or battery back-up systems may
not be compatible with the micro-processor electronics
on this appliance. Please consult the power supply
manufacturer for compatible systems.
WARNING! Risk of Fire! Hearth & Home Technologies
disclaims any responsibility for, and the warranty and agency
listing will be voided by the below actions.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overfire
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved.
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
Harman is a registered trademark of Hearth & Home Tech-
®
nologies.
3-90-436168i