Appliance Certification / Specifications; Mobile Home Approval; Btu & Efficiency Specifications - Harman XXV-TC Owner's Manual

1
Product Specific and Important Safety Information
A. Appliance Certification / Specifications
MODEL: XXV-TC Pellet Stove
LABORATORY: OMNI Test Laboratories, Inc
REPORT NO. 0135PS014S & 0135PS033E
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E 2779-10, ASTEM E 2515-
11, ASTM E 1509-04, ULC-S627-00
ELECTRICAL 115 VAC, 60 Hz, Start 4.2 Amps,
RATING
Run 2.8 Amps
GLASS
5mm mirrored ceramic glass
SPECIFICATIONS
The XXV-TC is Certified to comply with 2020
particulate emission standards.
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with
the ASTM E1509-2004, ULC S628-93, ULC/ORD-C-
1482-M1990, (UM) 84-HUD
B. Mobile Home Approval
This appliance is approved for mobile and manufactured
home installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pellet vent, Class "PL" or "L" connector pipe.
A Harman Outside Air Kit must be installed in a mobile home
®
installation.
!
T H E S T R U C T U R A L I N T E G R I T Y O F T H E
MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
Harman is a registered trademark of Hearth & Home
®
Technologies.
4
WARNING
Harman® • XXV-TC Owner's Manual_R5 • 2016 -___ • 02/17
C. BTU & Efficiency Specifications
EPA Certification Number:
EPA Certified Emissions:
*LHV Tested Efficiency:
**HHV Tested Efficiency:
***EPA BTU Output:
****BTU Input
Vent Size:
Hopper Capacity:
Fuel
* Weighted average LHV efficiency using data collected
during EPA emissions test.
**Weighted average HHV efficiency using data collected
during EPA emissions test.
***A range of BTU outputs based on EPA Default Efficiency
and the burn rates from the low and high EPA tests.
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU's which is the average BTU's from
a pound of pellets.
This wood heater has a manufacturer-set minimum low burn
rate that must not be altered. It is against federal regulations
to alter this setting or otherwise operate this wood heater
in a manner inconsistent with operating instructions in this
manual.
This wood heater needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this wood heater in a manner inconsistent with operating
instructions in this manual.
Risk of Fire! Hearth & Home Technologies disclaims any
responsibility for, and the warranty and agency listing will be
voided by the below actions.
DO NOT:
• Install or operate damaged appliance.
• Modify appliance.
• Install other than as instructed by Hearth & Home
Technologies.
• Operate the appliance without fully assembling all
components.
• Overfire.
• Install any component not approved by Hearth &
Home Technologies.
• Install parts or components not Listed or approved.
• Disable safety switches.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
55-16
1.75 g/hr
77.5%
72.5%
7,100 - 35,300
11,000 - 48,000
3 Inch
65 lbs
Wood Pellet
3-90-00680c