Product Specific And Important Safety Information; Appliance Certification; Glass Specifications; Mobile Home Approvals - Harman P43 Installation Manual

Freestanding
Table of Contents

Advertisement

1

Product Specific and Important Safety Information

A. Appliance Certification
MODEL:
P43 Pellet Stove
LABORATORY: OMNI Test Laboratories, Inc
REPORT NO.
135-S-23-4, 135-S-23b-6.2
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E 1509-04, ULC/ORD-
C1482-M1990, ULC-S627-00
MODEL:
P61A Pellet Stove
LABORATORY: OMNI Test Laboratories, Inc
REPORT NO.
135-S-22-4, 135-S-22b-6.2
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E 1509-04, ULC/ORD-
C1482-M1990, ULC-S627-00
MODEL:
P68 Pellet Stove
LABORATORY: OMNI Test Laboratories, Inc
REPORT NO.
135-S-13-2, 135-S-13b-2,
135-S-13c-6.2
TYPE:
Pellet Fueled/Supplementary For
Residential Use
STANDARD(s):
ASTM E 1509-04, ULC/ORD-
C1482-M1990, ULC-S627-00
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with
the ASTM E1509-2004, ULC S628-93, ULC/ORD-C-
1482-M1990, (UM) 84-HUD
The P61A and P68 Freestanding Pellet Stove by Harman®
are exempt from Environmental Protection Agency
certification under 40 CFR 60.531 by definition [Wood
Heater (A) "Air to Fuel Ratio].
The P43 is EPA certified to comply with July 1990 particulate
emission standards.
4
Harman® • P-Series Installation Manual_R3 • 2014 -___ • 09/14
B. Glass Specifications
This appliance is equipped with 5mm mirrored ceramic
glass. Replace glass only with 5mm ceramic glass. Please
contact your dealer for replacement glass.
C. Mobile Home Approved
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided.
The structural integrity of the mobile home floor, ceiling, and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pellet vent, Class "PL" connector pipe.
A Harman
Outside Air Kit must be installed in a mobile home
®
installation.
!
T H E S T R U C T U R A L I N T E G R I T Y O F T H E
MANUFACTURED HOME FLOOR, wALL, AND
CEILING/ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
WARNING
3-90-436168i

Advertisement

Table of Contents
loading

This manual is also suitable for:

P61aP68

Table of Contents