GENERAL INFORMATION This appliance is designed for domestic household use. The User Manual contains important product safety & installation information. Your safety is of the utmost importance. Please ensure you read this booklet before attempting to install or use the appliance, and contact RambleWood Green if you have any question.
IMPORTANT: The German Shcott ceramic glass is tough; however it is not unbreakable and can be damaged if heavy or sharp objects are placed on top. DO NOT USE THE UNIT IF ITS SURFACE IS BROKEN OR CRACKED. YOU SHOULD CONTACT RAMBLEWOOD GREEN IMMEDIATELY. Specifications Product specifications and Electrical details : ●...
OPERATION GUIDE First Time Use Any film or stickers on the glass surface should be removed before use. You should switch on one cooking zone at a time, for 5 minutes at maximum level. This will help to remove any odor and evaporate any humidity formed inside the unit after exit factory.
INSTALLATION The installation and service must be conducted by a qualified / licensed technician, in accordance with national & local regulation. Product dimensions and Aperture dimensions: MODEL EC2-30 290mm 510mm 270mm 490mm 53mm Unpacking the appliance When unpacking the appliance please check the following items are contained...
Page 6
Cut a hole in counter top per drawings shown above. IMPORTANT: You must leave clearance of at least 25 mm between the underneath of the unit and any surface below it. Carefully turn the hob upside down and place it on a cushioned mat. ...
Page 7
(A) Clip (B) Fixing bracket (C) Screw You should insert a clip (A) into the holes which are located in each corner of the hob. Place the fixing brackets (B) over each hole and clip, and then place a screw (C) through the hole and fixing bracket (B).
Page 8
Replacing the mains supply cable If the power cord is damaged, it must be replaced by manufacturer or qualified technician, per national & local safety regulation/guideline. The main terminal block is located on the underside of the hob and terminals are accessible by removing the terminal block cover screw.