& installation information. Your safety is of the utmost importance. Please ensure you read this booklet before attempting to install or use the appliance, and contact RambleWood Green if you have any question. Safety Guideline Read these instructions carefully before installing or using this appliance.
Product Overview Auxiliary Burner 2. Semi-rapid Burner 3. Triple Ring Wok Burner 4. Ignitor for Gas Burners 5. Safety Device (Thermal couple flame out control) - Activated if the flame accidentally goes out (spills, drafts, etc.). Thermal couple will shut off the gas supply. 6.
Specification GC4-50N MODELS Cooking Zone Input Voltage 110V AC Output Power 2800 + 5000 + 5000 + 9500 BTU Front Side control operation Product Size D×W×H (Inch) 23 x 20 x 4 Cut Out Dimensions D x W (Inch) 22 ×19 User Instruction The position of the corresponding gas burner is indicated on each control knob.
Page 5
Caution: If the flame goes out accidentally, turn off the gas with the control knob and try to light it again at least 1 minute later. Convert to LPG/Propane use 1. The package comes with 4 LPG/Propane burner orifices sealed in a small bag. User need to replace the 4 burner orifices.
Maintenance Before cleaning or performing maintenance, please disconnect cooktop from the electrical power. The removable parts of the burners should be washed with warm water and soap, make sure to remove baked-on substance. Automatic igniter pin, the end must be cleaned carefully and usually. ...
Installation Clearance requirement It’s recommended to leave at least 3 inches of clearance underneath the unit bottom. For countertop installation recommendation please refer to pictures below, Fig.6 Hook position for Hook position for Hook position for H=20mm top H=30mm top H=40mm top N.B: Use the hooks contained in the "accessories bag"...
Connection to city gas supply line The gas inlet pipe connector thread size is 0.5 inches. (1/2 inches). Please seal all joints with thread sealing tape to prevent leakage. Gas Leakage Warning Once the cooktop installed, make sure all the connections are properly sealed, use soapy water to test leakage, &...