These high efficiency cooktops are designed for domestic household use. The User Manual contains important product safety & installation information. Your safety is of the utmost importance. Please ensure you read this booklet before attempting to install or use the appliance, and contact RambleWood Green if you have any question. Safety Information ...
OPERATION GUIDE Operation Any film or stickers on the cooktop surface should be removed before use. All operations are performed by means of the 2 control knobs. Knob controls electric ignition, safety device & flame level. To Ignite, press, hold & turn the knob for 1~2 seconds to light up the gas, & allow the ...
INSTALLATION Installation and service must be conducted by qualified / licensed technician, in accordance with national & local regulation. Failure to comply will void the product warranty. Always disconnect the appliance power before installation & maintenance. These cooktops are designed to be dropped into counter top measuring >24 inches in depth.
Page 5
INSTALLATION IN KITCHEN CABINET WITH DOOR (fig.13) It is recommended that a 30 mm clearance be left between the cooker top and the fixture surface (fig.13). Note: The adjacent furniture and all materials used in installation must be able to withstand a minimum of 85°C above the ambient temperature.
Page 6
SETTLING THE HOB FOR INSTALLATION Every cooktop is provided with a set of tabs for fitting to the unit with thickness from 3 to 4 cm, and a seal with adhesive on one side. • Remove burners and grids. • Turn the cooktop over and rest the top side on a cloth. •...
Page 7
GC2-48P GC1-28N GC1-28P GC2-43N GC2-43P A cardboard with cut out hole size is packed in each box. Please use it to outline & cut hole in the counter top. Do not attempt to cut the hole before you received the unit & measure its cut out...
America standard Three Quarter Inches (3/4”) thread size connector for gas supply hose connection. If you can not locate this connector inside the box please contact Ramblewood Green at sales@ramblewoodhk.com or toll free number 1-888-880-8351. There is guideline in each product’s Web. Page, “User Manual 2”, to illustrate the operation.
Page 9
• Regulation of the burner flame level Inside the box there is one pair of gas burner jets for opposite gas type, sealed in a small bag. Please contact Ramblewood Green if you can not locate this conversion kit. Remove the gratings and the burner covers;...
Page 10
Regulation of the burner flame level; When switching from one type of gas to another, the minimum flow rate must be adjusted so the flame should not go out. To regulate the flame follow; • Light up the burner • Turn the knob to minimum level •...
Cleaning and Maintenance Cleaning Glass surface should be cleaned regularly. Avoid using acid or chlorine-based cleaning products. Burner & grids can be removed and cleaned with appropriate detergent. After cleaning it is very important to check that the burner flame distributor F and the cap ...
Page 12
be able to rotate (fig.8). Then position the cap A and the ring B (fig.8). CLEANING THE TRLPLE RING BURNER Four holes( “H”) outside the crown can be cleaned by removing the flame divider (fig.9) and use a cotton bud to brush out any dirt trapped inside,. This procedure is necessary to ensure the burner functions correctly.