Installation Planning; Location And Clearances; Outside Combustion Air - Napoleon HYBRID 100 Installation And Operating Instructions Manual

8

3.0 INSTALLATION PLANNINg

kEEp HAND TOOLs IN gOOD CONDITION, sHARpEN CUTTINg EDgEs AND MAkE sURE TOOL HAN-
DO NOT UsE MAkEsHIFT COMpROMIsEs DURINg INsTALLATION. DO NOT BLOCk OR REsTRICT AIR.
DO NOT IMpEDE AIR MOvEMENT zONEs MARkED "CLEARANCE TO COMBUsTIBLEs".
BEFORE INsTALLINg THIs AppLIANCE, CONTACT THE LOCAL BUILDINg OR FIRE OR OTHER AU-
THIs AppLIANCE MUsT BE INsTALLED BY A qUALIFIED INsTALLER. FOLLOw THE INsTALLATION
DIRECTIONs. DO NOT OpERATE wITHOUT FULLY AssEMBLINg ALL COMpONENTs.
IF THIs AppLIANCE Is NOT pROpERLY INsTALLED, A HOUsE FIRE MAY REsULT.
3.1

LOCATION ANd CLEArANCES

DO NOT INsTALL INTO ANY AREA HAvINg A CEILINg HEIgHT LEss THAN THE MINIMUM CEILINg
THIs AppLIANCE, CONFIgURED wITH ALL MODULEs, wEIgHs: 480 LBs (218 kg). ENsURE THERE Is
for detailed clearance to combustibles, plenum and venting considerations, see section 5.0.
3.2

OuTSIdE COmBuSTION AIr

DO NOT DRAw OUTsIDE AIR FROM gARAgE spACEs. ExHAUsT pRODUCTs OF gAsOLINE COM-
DO NOT DRAw OUTsIDE AIR FROM ATTIC spACEs, BAsEMENTs OR ABOvE THE ROOFINg wHERE
OTHER HEATINg AppLIANCEs OR FANs AND CHIMNEYs ExHAUsT OR UTILIzE AIR. THEsE pRE-
CAUTIONs wILL REDUCE THE pOssIBILITY OF AppLIANCE sMOkINg OR AIR FLOw REvERsAL.
NEgATIvE pREssURE wITHIN YOUR HOME MAY INADvERTENTLY AFFECT YOUR AppLIANCE. Ex-
HAUsT FANs sUCH As BATHROOM FANs, RANgE HOODs AND CLOTHEs DRYERs CAN sTRONg-
AIR INLET TERMINALs MUsT BE INsTALLED wITH ADEqUATE gROUND CLEARANCE AND BE
sUFFICIENTLY sHIELDED FROM pREvAILINg wINDs TO pREvENT FROM REvERsINg IN THE vENT
this appliance draws combustion air from the room and the installer must ensure adequate make up air is
available.
fresh air makeup for solid fuel furnaces must follow criteria set out in installation standard Can/Csa-b365-01
annex d "outside Combustion air" (see pages 9 and 10).
exhaust fans within the house must not create negative pressures within the room where the furnace is operat-
ing.
W415-1066 / C / 06.22.12
wEAR gLOvEs AND sAFETY gLAssEs FOR pROTECTION.
THORITY HAvINg jURIsDICTION AND FOLLOw THEIR gUIDELINEs.
HEIgHT REqUIREMENTs LIsTED IN sECTION 5.3.1.
ADEqUATE FLOOR sUppORT FOR THE AppLIANCE.
BUsTION ENgINEs ARE HAzARDOUs.
LY INFLUENCE NEgATIvE pREssURE IN THE HOUsE.
DLEs ARE sECURE.
sYsTEM.