Step 2 - Add Gasoline - Sportsman GEN7000 Instruction Manual

Step 2 - Add Gasoline

Gasoline and gasoline fumes are highly flammable and explosive. Handling fuel can result in serious injury or burns.
• Do not fill the fuel tank near a heat, sparks or an open flame. Keep gasoline away from appliance pilot lights, barbecues, electric appliances, power
tools, etc.
• Do not overfill the fuel tank. Always check for fuel spills and immediately wipe them up. Spilled fuel is a fire hazard and causes environmental
damage.
To add gasoline:
To ensure that this generator runs smoothly, use only FRESH, UNLEADED GASOLINE WITH AN OCTANE RATING OF 87 OR HIGHER. Unleaded
gasoline produces fewer engine and spark plug deposits and extends the life of the exhaust system.
1. Confirm that this generator is on a level surface.
2. Unscrew fuel tank cap and set aside. (NOTE: The fuel tank cap may be tight and difficult to unscrew.)
3. Slowly add fresh, unleaded gasoline (with an octane rating 87 or higher) to the fuel tank. Be careful not to fill the fuel tank above the upper limit
line. The fuel tank capacity for this Model GEN7000 7000 Surge Watts / 6000 Running Watts Electric Start Portable Generator is 7 gallons (26.5 L).
The fuel gauge, located on the top of this generator, indicates how much gasoline is currently in the fuel tank. NOTE: Because gasoline can expand,
do not fill the fuel tank to the very top.
4. Securely tighten the fuel tank cap and immediately wipe up any spilled gasoline with a dry cloth.
Model GEN7000 Fuel Tank Capacity (gals /L)
Model GEN7000 Fuel Type
IMPORTANT:
• Use only UNLEADED gasoline with an octane rating of 87 or higher.
• Never use a mixture of oil and gasoline.
• Never use old and/or contaminated gasoline.
• Avoid getting dirt and/or water in the fuel tank.
• Gasoline can age in the fuel tank and make it difficult to start this generator. Never store this generator for extended time with gasoline in the fuel
tank.
Step 2 – Connect the Battery
The generator does not come equipped from the factory with a battery. A battery must be installed before the electric start feature can be used.
(A 12 Volt motorcycle battery no larger than 7 1/4" length, 6 1/2" height, and 3" width is required for electric start of this generator.
(The ideal battery required is 7 1/8" L x 6" H x 3'W, 130 Min CCA Cold Cranking Amps)
Comparable brands/models are: Yuasa: YB9A-A, YB9-B or YB9L-B, Delco: CB9A-A, NAPA: 740-1872, 740-1858, 740-1837
Sears: 44043, 44356, 44045, Generic brand SLA-12V22
**Brands/model numbers can change, this information is intended as a guide only, if your sparkplug needs to be replaced, please visit your local auto
parts store for their recommendation, or call 1-866-460-9436 Monday - Friday, 8 AM - 4 PM Central Time for customer service for assistance**
The battery case is located below the control panel.
Install the battery by using the two cables (one red and the other black) that are attached to the engine.
Disconnect all electrical loads from this generator before changing the battery.
Attach the red/positive cable to the positive terminal on the battery.
Attach the black /negative cable to the negative terminal on the battery.
Slide the battery into the battery case.
GEN7000 7000 Watt Generator Manual
7 / 26.5
Fresh, Unleaded Gasoline Octane Rating 87 or Higher
12