CEStronics RF-NET Repeater Fitting And Operating Instructions page 17

Wherever possible, you should check the reception before the
final fastening to determine the orientation of the Repeater and
the antenna:
For this purpose, put the Repeater temporarily into service

(see page 18 ff).
Verify the reception at your locking devices with the RF-

TRACE-MASTER card (see page 12).
The orientation of the antenna can be adjusted. As long as the
antenna has not yet been screwed in tight, it can be rotated by
360°. After it has been tightened, the antenna can only be
aligned vertically and horizontally.
If the RF link is satisfactory, fit the Repeater permanently in

the determined position:
Fasten the wall mount with suitable fasteners at a right

angle at its proper position.
RF-NET Repeater
Fitting the Repeater
17