Summary of Contents for CEStronics RF-NET Repeater
- Page 1 RF-NET Repeater Fitting and Operating Instructions Translated Fitting and Operating Instructions Version 1.2, 09/2012...
-
Page 2: Preface
Preface Preface These Fitting and Operating Instructions will help you fit and use the RF-NET Repeater (Repeater) as intended, safely, and advantageously. Any person who fits, operates, or disposes of this Repeater must have read and understood the entire contents of these Fitting and Operating Instructions. -
Page 3: Table Of Contents
Connections ..............11 RF ranges ..............12 Fitting the Repeater ............ 14 Trouble shooting ............21 Maintenance ..............24 Spare Parts ..............24 Disposal ............... 24 Technical data ............. 25 Glossary ..............26 Notes on the manufacturer's warranty ......27 RF-NET Repeater... -
Page 4: For Your Safety
Always keep the Repeater out of reach of children. There is a risk that children swallow small parts such as batteries or screws. Danger of property damage Always have repairs performed by properly qualified personnel. Only use accessories and spare parts recommended by CEStronics. RF-NET Repeater... - Page 5 Repeater and all other system components are in perfect working order. Malfunctions of the Repeater and other system components may compromise the functioning of the entire system. If necessary, use uninterrupted power supply (UPS) systems to ensure an uninterrupted operation of your locking system. RF-NET Repeater...
-
Page 6: Explanation Of The Safety Notes
Explanation of the safety notes These Fitting and Operating Instructions include safety notes of the following types: CAUTION CAUTION notes warn against hazards that may result in slight or medium injuries. Notes NOTICE Notes warn against possible property or environmental damage. RF-NET Repeater... -
Page 7: Intended Use
Any other use is considered to be improper and may result in property damage or even personal injury. CEStronics GmbH does not accept any liability for any damage resulting from improper use. Versions These Fitting and Operating Instructions are only valid for: ... -
Page 8: Introduction
Two colour LEDs for visual signalization of data traffic. The stated maximum range increase of 25 metres cannot be guaranteed as it depends on the local building conditions. CEStronics recommends to have your building situation checked by your professional CEStronics partner. -
Page 9: Components Of A Wireless System With Repeater
Repeaters extend the radio link between your Access Points and locking devices by up to 25 metres. The following components are required for the system: Standard PC (1) with installed OMEGA software OMEGA Access Points (2) Locking devices (3) Repeater (4) RF-NET Repeater... -
Page 10: Scope Of Delivery
check the contents of the package and the scope of delivery. Check new devices for transport damage and inform your CEStronics partner promptly if any damage is found. Device overview Repeater Plug-in power pack with connecting cable Housing parts... -
Page 11: Unpacking The Repeater
Risk of damage to the Repeater. Only use the plug-in power supply delivered with the device to supply your Repeater with power. Connections Socket for the plug-in power supply LEDs for signalling RF traffic and server connection Screw terminal for the antenna RF-NET Repeater... -
Page 12: Rf Ranges
The maximum RF distance between Access Point (1) and Repeater (2) is 25 metres. The maximum RF distances between Repeater (2) and locking devices (3) is 25 meters. The RF range may vary considerably depending on the building situation. See also note on page 8. RF-NET Repeater... - Page 13 To verify the quality of the RF link to your locking devices, proceed as follows: Hold the RF-TRACE-MASTER in front of your locking device. The verification is performed immediately. During the verification, the Access Point emits the same signals as the locking device. RF-NET Repeater...
-
Page 14: Fitting The Repeater
Only skilled personnel may fit the Repeater. This personnel must have been trained on the product by CEStronics or a CEStronics partner. NOTICE Static charges may damage or interfere with the electronic components of the Repeater. Do not disassemble the Repeater in rooms with ... - Page 15 Purchase suitable fasteners material from your specialized fasteners dealer. CAUTION Danger of injury by improper fitting. Ensure that the Repeater is only fitted by appropriately trained skilled personnel. RF-NET Repeater...
- Page 16 Other fitting positions are possible but the operator's responsibility. In case of lateral fitting, you, as the operator, are responsible for the safe fitting. NOTICE Danger of injury by improper fitting. Ensure safe fitting if the repeater is fitted laterally. RF-NET Repeater...
- Page 17 360°. After it has been tightened, the antenna can only be aligned vertically and horizontally. If the RF link is satisfactory, fit the Repeater permanently in the determined position: Fasten the wall mount with suitable fasteners at a right angle at its proper position. RF-NET Repeater...
- Page 18 Do not yet screw the antenna (1) tight into the antenna base (2) at this time. Do not use any tools for tightening. Establish the required cable connections as described on page 11 "Connections". Put the Repeater into service. RF-NET Repeater...
- Page 19 The antenna is tight if it can no longer be rotated. NOTICE The printed circuit board of the Repeater may be damaged through mechanical forces. Be careful not to damage the printed circuit board when fitting the antenna. RF-NET Repeater...
- Page 20 Normal operation Signal location Meaning Does the data exchange with locking devices work? The two LEDs signal the following conditions: Signal Meaning Green LED, flashing Data exchange with locking devices Red LED, flashing Operative RF-NET Repeater...
-
Page 21: Trouble Shooting
Check the plug-in power supply for mechanical damage. Check the signalization of the LEDs Eliminate any interruptions and repair any damage found. In case of mechanical damage, have your Repeater repaired by your CEStronics partner. RF-NET Repeater... - Page 22 For further information on the replacement of batteries, please refer to the operating instructions of your locking devices. No connection to The OMEGA software is not configured the locking devices correctly. Your PC does not work RF-NET Repeater...
- Page 23 OMEGA User Manual. Verify the perfect functioning of your If you are not able to verify the perfect functioning, please contact your PC dealer. If the trouble still cannot be eliminated, please contact your CEStronics partner. RF-NET Repeater...
-
Page 24: Maintenance
Maintenance Maintenance Have the Repeater serviced and its perfect functioning verified every six months by CEStronics or by a CEStronics partner only. Spare Parts The Repeater does not require any spare parts for you to change. If you need service, please contact your professional ... -
Page 25: Technical Data
RF range: approx. 25 m Temperature rage: 0 °C to +40 °C Environmental conditions: Not suitable for use in corrosive atmospheres (chlorine, ammonia, lime water). Maximum air humidity: 95 % Service life of the At least 10 years Repeater: RF-NET Repeater... -
Page 26: Glossary
An optional Master card which enables you RF-TRACE- to test the quality of your RF link. Master The distance within which a safe RF range transmission of data is possible. RF-NET Repeater... -
Page 27: Notes On The Manufacturer's Warranty
The information and data contained in this document are subject to change without notice. Without the express written permission by CEStronics, no part of this document may be copied or transmitted for any purpose. © 2011 CEStronics GmbH, Velbert/Germany Art. - Page 28 +49 (0)2051-204-0 +33 (0)1-43 07 35 78 +49 (0)2051-204-229 info@fr.ces.eu info@ces.eu www.ces.eu/fr www.ces.eu CEStronics GmbH CESnederland B.V. Friedrichstraße 243 Lage Brink 9 D-42551 Velbert NL- 7317 BD Apeldoorn +49 (0)2051-204-0 +31 (0)55-52 66 89-0 +49 (0)2051-204-229 +31 (0)55-52 66 89-9 ...