Foxconn 915G Manual page 17

Memory
This motherboard includes two 184-pin slots with 2.6V for DDR and two 240-pin
slots (optional) with 1.8V for DDR2. DIMM1 and DIMM3 slots support 256 Mb,
512 Mb and 1 Gb DDR2 technologies for x8 and x16 devices; DIMM2 and DIMM4
slots support 256 Mb, 512 Mb and 1 Gb DDR technologies for x8 and x16 devices.
You must install at least one memory bank to ensure normal operation.
Memory Configuration Table
Use any of the recommended configurations in the following table
Channel Mode
Single-
Channel
Dual-Channel
Attention:
1. Before you install memory modules, please make sure that all
DIMMs in one system are of the same type (e.g. all DDR or all
DDR2, not mixed).
2. If DDR and DDR2 memory banks are installed simultaneously
or all four sockets are populated with DIMMs, the buzzer will alarm
for memory error warning and power-on failure may result. But
in this case, it can not cause any damage to your motherboard
and memory banks since an exclusive protection circuit is spe-
cially designed for it.
For the latest memory modules support list, please visit the website:
http://www.foxconnchannel.com
10
Chapter 2
DDR
Type
DIMM1 DIMM2
x Populated
DDR
x
Populated
DDR2
x
x Populated
DDR
Populated
DDR2
Installation Instructions
DIMM
DIMM3
x
x x Populated
x x
x Populated
x Populated
x Populated
DIMM4
x
x
x
x