System Setup - First Steps; Introduction; Setup Instruction; Starting The Application - Bosch DIP-3040-00N Installation Manual

12 en | System setup - first steps
4

System setup - first steps

The following installation directive provides information on Installation and Configuration.
DIVAR IP systems are based on Windows Storage Server 2008 R2 operating system.
This chapter is valid for DIVAR IP models that come with pre-installed hard drives. Empty units
start into the DOM recovery menu on first start.
See also:
–
4.1

Introduction

DIVAR IP systems are shipped with a pre-installed Configuration Wizard from factory.
4.2

Setup instruction

All DIVAR IP systems are preconfigured with a default IP address and with default iSCSI
settings.
–
–
Observe the following:
–
–
–
–
User with administrator rights:
–
–
Notice!
We strongly recommend not changing the user settings. Changing the user settings can result
in malfunctioning of the system.
4.3

Starting the application

DIVAR IP system is ready to go out of the box. The application provides a simple to install and
intuitive to use solution for network surveillance systems.
Notice!
In order to start the application for the first time you must use the VGA port. If the system is
only connected to the DVI port, no video signal is displayed until the system has started
completely. This can take 1 – 2 minutes. A video signal is always displayed when the monitor
is connected to the VGA port.
To start the application:
1.
2.
2014.03 | V4 | DOC
Recovering the unit, page 30
IP Address: 192.168.0.200
Subnet mask: 255.255.255.0
DIVAR IP needs to have an active network link during installation. Make sure that the
network switch you are connecting to is powered on.
The default IP address must not be occupied by any other device in the network. Make
sure that the default IP addresses of existing DIVAR IP systems in the network are
changed before adding another DIVAR IP.
Determine whether the initial installation is on a DHCP network. If not then you must
assign valid IP addresses to the video devices. Consult the local IT administrator to obtain
a valid IP address range to be used with DIVAR IP and associated devices.
The default iSCSI settings are optimized for use with VRM.
User: BVRAdmin
Password: WSS4Bosch
Connect the unit and the cameras to the network.
Turn on the unit.
The Windows Storage Server 2008 R2 setup process starts.
Installation Manual
DIVAR IP 3000
Bosch Sicherheitssysteme GmbH