System Setup - First Steps; Introduction; Setup Instruction; Starting The Application - Bosch DIP-2040-00N Installation Manual

12 en | System setup - first steps
4

System setup - first steps

The following installation directive provides information on Installation and Configuration.
DIVAR IP systems are based on Windows Storage Server 2008 R2 operating system.
4.1

Introduction

DIVAR IP systems are shipped with a pre-installed Configuration Wizard from factory.
Intended use for Configuration Wizard is the quick and easy configuration of a smaller system.
Configuration Wizard helps you to achieve a configured system including VRM, iSCSI system,
cameras, recording profiles and user groups.
User groups and their permissions are configured automatically. You can add or remove users
and set passwords.
Configuration Wizard can access Management Server only on the local computer.
You can save an activated configuration for backup purposes and import this configuration
later. You can change this imported configuration after import.
You must add iSCSI systems manually.
Configuration Wizard adds the local VRM automatically.
4.2

Setup instruction

All DIVAR IP systems are preconfigured with a default IP address and with default iSCSI
settings.
–
–
–
–
The default iSCSI settings are optimized for use with VRM.
Notice!
We strongly recommended not changing these settings. Changing these settings can result in
malfunctioning of the system.
4.3

Starting the application

DIVAR IP system is ready to go out of the box. The application provides a simple to install and
intuitive to use solution for network surveillance systems.
To start the application:
1.
2.
3.
4.
5.
6.
7.
2013.05 | V1 | DOC
IP Address: 192.168.178.200
Subnet mask: 255.0.0.0
User: Administrator
Password: WSS4Bosch
Connect the unit and the cameras to the network.
Turn on the unit.
The Microsoft and Bosch EULA (End-user license agreement) is displayed.
Accept the EULA, then click Next >.
The logon screen for the default user is displayed.
Enter the default password WSS4Bosch.
A message is displayed that you must change the password.
Change the password, then click OK.
Change the network settings according to your IP environment.
The default screen is displayed.
Double-click the Configuration Wizard icon to start the Configuration Wizard.
The Welcome page is displayed.
Installation Manual
DIVAR IP 2000
Bosch Sicherheitssysteme GmbH