Jacking Instructions; Jacking Instructions; Safety And Instruction Decals; Safety And Instruction Decals - Toro Sand Pro 5040 Service Manual

Jacking Instructions

CAUTION
When changing attachments, tires or perform-
ing other service, use correct blocks, hoists
and jacks. Make sure machine is parked on a
solid level floor such as a concrete floor. Prior
to raising the machine, remove any attach-
ments that may interfere with the safe and
proper raising of the machine. Always chock
or block wheels. Use jack stands or solid
wood blocks to support the raised machine. If
the machine is not properly supported by
blocks or jack stands, the machine may move
or fall, which may result in personal injury.
Use the following positions when jacking up the ma-
chine:
Front End Jacking
1. Jack the front of the machine from the bottom of the
frame behind the front wheel (Fig. 1). Make sure that
jack is positioned directly under frame to prevent dam-
age to oil cooler.
Rear End Jacking
1. Jack the rear of the machine from below the wheel
motor (Fig. 2).

Safety and Instruction Decals

Numerous safety and instruction decals are affixed to
the Sand Pro and Infield Pro. If any decal becomes illeg-
ible or damaged, install a new decal. Part numbers for
replacement decals are listed in your Parts Catalog. Or-
der replacement decals from your Authorized Toro Dis-
tributor.
Safety
1. Front wheel
1. Rear wheel motor
Page 1 – 4
1
2
Figure 1
2. Front jacking point
1
2
Figure 2
2. Rear jacking point
Sand Pro & Infield Pro 3040/5040