Adjustment Of The Transfer Ribbon - Industrial Labeling Systems Ultimate 3000 Series Quick Operator's Manual

Adjustment of the Transfer Ribbon

1
2
In the event that wrinkles appear in the transfer ribbon ( 1), which cause an
inconsistent print image, the transfer ribbon shield ( 2) can be adjusted to
remove the wrinkles. The adjustment should be done during the printing
process.
1. The current position is visible on the scale ( 3).
2. T o change the position, rotate the knurled knob ( 4). Rotating it in the
direction of "+" will tighten the transfer ribbon the inner edge of the transfer
ribbon. Rotating it in the direction of "-" will tighten the outer edge of the
transfer ribbon.
To eliminate the wrinkles, tighten the side where the wrinkles are
originating.
Figure 6
3
4
5