Test Options - Industrial Labeling Systems Ultimate 3000 Series Quick Operator's Manual

Test Options

The printer is equipped with several test options, which are summarized in the
"Test" menu of the offline menu.
1. Switch from the "Online" mode to the Offline Menu by pressing the
2. Press the
Press the
3. For all test print options load media and transfer ribbon which extends over
the entire print width of the printer.
4. Select the test option to be carried out by pressing the
Press the
Test
Short status
Shows the most important information about the printer configuration on LCD.
Use the
To leave the "Short status" display , press the
Status print
Printout of the most important setup and status information and a test pattern to
display the quality of the print image (Fig. 8).
Font list
The important parameters of the font available in the printer are printed as a
table. The table contains both the fonts saved in the printer internal memory and
the fonts loaded into the printer.
Device list
The hardware components installed in the printer and the optional devices
connected to the printer are displayed in this list.
Printhead profile
A diagram will be printed which shows the resistance values for the single
printhead dots. When a dot is damaged or defective its resistance value
increases.
ASCII dump mode
Method to print the control sequences sent to the interface. After starting the
ASCII dump mode a print job is to send. The data received will be printed in text
format depending on the selected character set (Fig. 10). Press the
to return to "Online" mode.
Test grid
Printout of a test grid to evaluate and check the quality of the printed image.
Label profile
Printout of a diagram with the values measured by the label edge sensor during
the media feed.
10
key.
key or the
key to confirm the selection.
key to confirm the selection.
key or the key to move between the different pieces of information.
key until the "Test" menu is displayed.
key.
key or the key.
key