Loading Labels - Industrial Labeling Systems Ultimate 3000 Series Quick Operator's Manual

Loading Labels

The following steps are valid for loading labels in tear-off mode.
Instructions for loading labels in rewind or dispense mode and for loading
fanfold labels can be found in the Printer's Operator Manual or in the
documentation of the Present Sensor.
1. Loosen the knurled screw (3), swing the media retainer (4) upwards and
2. Place the media roll (5) onto the media hub (6) and unwind a strip of
3. Swing the media retainer (4) downwards until it touches the media hub ( 6).
4. Raise the printhead assembly (1) by rotating the lever (2) clockwise until it
5. Slide the media guide ring (7) outward, allowing enough clearance for the
6. Slide the media strip through the printer as shown in figure 2. The feed
7. Move the label edge sensor assembly ( 8) in such a position that the
2
1 2
7
slide it out as far as possible.
media from the media roll. Make sure the labels are facing up. Slide the
roll onto the media hub (6) until its stops.
Push the media retainer against the supply role until it rests against the
label media. Tighten the knurled screw (3).
stops.
label stock's width when loaded.
path for labels wound-out is represented by a solid line, and the feed path
for wound-in labels is represented by a broken line.
sensor (9) itself can detect label gaps, notches or reflective marks.
The adjustment of the sensor is performed by sliding the handle ( 10) in
and out.
3
Figure 2
4 5
6