Power Connection - Lowrance HDS-7 HDS Gen3 Installation Manual

20 |

Power connection

The plug of the supplied power cable has two discrete cables
exiting from it. The thickest of the two cables provides the following:
• power into the system (Red and Black wires)
• remote turn-on for certain Navico expansion modules (Yellow wire)
1
1 HDS display rear (HDS9/12 connector arrangement shown)
2 Power cable
3 12 V positive wire (red) shown with fuse holder installed
inline
4 12 V negative wire (black)
5 Accessory Wake Up wire (yellow)
6 Vessel's 12 V DC supply
Accessory wake up
The yellow colored accessory wake up line may be used to
control the power state of Navico modules such as SonicHub,
StructureScan, and Broadband radar. This means that the modules
are turned on the moment the display is powered up. For
connection, simply combine all yellow wires on a common bus or to
a single termination point.
 Note:
Broadband radar will be started in 'standby' mode, never
'transmit' mode, when triggered by the accessory wake up line.
The following demonstrates the power connections for a typical
small system.
Wiring | HDS Gen3 Installation Manual
2
4
6
3
_
+
5