Table of Contents
Advertisement
14 |
Power connection
The plug of the supplied power cable has two discrete cables
exiting from it. The thickest of the two cables provides the following:
•
power into the system (Red and Black wires)
•
remote turn-on for certain Navico expansion modules (Yellow wire)
1
1
HDS-7 Gen3 Polaris display rear
2
Power cable
3
12 V positive wire (red) shown with fuse holder installed
inline
4
12 V negative wire (black)
5
Accessory Wake Up wire (yellow)
6
12 V DC supply
Accessory wake up
The yellow colored accessory wake up line may be used to control
the power state of Navico modules such as SonicHub or WM-3
SiriusXM weather receiver. This means that the modules are
turned on the moment the display is powered up. For connection,
simply combine all yellow wires on a common bus or to a single
termination point.
Wiring |
HDS Gen3 Polaris Installation Manual
3
4
+ _
5
6
2
Advertisement
Table of Contents
