Ethernet Setup - Lowrance HDS-7 HDS Gen3 Installation Manual

Commonly used sentences are enabled by default.
NMEA 0183 over Ethernet
The NMEA 0183 data stream is also output over ethernet, which is
made available to tablet devices and PCs, using the WIFI-1 wireless
adaptor.
The Ethernet dialogue provides IP and port data typically required
for confi guring the application on the third party device.
 Note:
Other MFDs can't decode this information back to NMEA 0183,
to use the data as a source. To share data a physical NMEA 2000 or
NMEA 0183 connection is still required.

Ethernet setup

No special setup is required for establishing an ethernet network, it
is all 'plug and play' . An optional NEP-2 connected between the HDS
Gen3 and another network module (e.g. 4G radar) will automatically
start working, and relay data between the two devices.
Diagnostics
The UDB (User Data Base) tab on the diagnostics page, provides
information on Ethernet activity, as shown below.
The 'Reset Display List' can be used to refresh the list of connected
44 |
Software setup | HDS Gen3 Installation Manual