Device List - Lowrance HDS-7 HDS Gen3 Installation Manual

32 |
Confi gure device
Additional device options can be confi gured from both the Data
source menu or from the Device list, see "Device list" on page 32
for further information.
Scope
The active data source under any given category, can be set to be
Global or Local.
When a source is set as Global, it will be used by all displays on the
network. When a source is set as Local, it will only be used by the
display that selected it as the source.
 Note:
If changing a display from a Global source to a diff erent Local
source, change the Scope setting to Local before changing the
selected source, otherwise all other displays will be changed over to
the new source.
 Note:
Local and Global data settings apply to the selected data
source only. It is not possible to discretely set whether a data source
is Global or Local if it is not the active source on the display being
operated.
Reset Global/Local
Selecting Reset Global will run an Auto data source selection,
and override all previous manual source selections made on all
networked devices. Reset Local will revert all data source selections
on the display being used to the Global source settings available
from other networked displays.

Device list

The device list shows the physical and virtual devices that provide
data. This may include a module inside the HDS Gen3, the NMEA
0183 port, or any external NMEA 2000 device.
Selecting a device in this list will bring up additional details and
possible actions:
Software setup | HDS Gen3 Installation Manual