3Com ETHERLINK III LAN PC CARD User Manual page 59

6-8 C 6: T
HAPTER
3 Inspect all cables and connections.
Use the supplied cabling. Refer to Chapter 2.
4 Make sure that your PC is running DOS 3.1 or later, and
that no network device drivers are loaded.
5 Make sure that the I/O Base Address and the Interrupt
Request Level settings for the PC Card are not the same
settings used on other cards or system units.
To display the 3C589C PC Card settings, see the "Displaying
Configuration Information" section in Chapter 5.
6 Use only the drivers that are on the EtherDisk diskette that
shipped with the 3C589C PC Card. The EtherDisk diskette
contains the following four drivers:
Novell NetWare DOS ODI driver (3C589.COM)
Novell NetWare OS/2 ODI driver (3C589.SYS)
NDIS 2.1 DOS driver (ELPC3.DOS)
NDIS 2.1 OS/2 driver (ELPC3.OS2)
7 If you are running the echo exchange test, make sure that
the PC Card is connected to a properly cabled and inactive
network and that an echo server is set up on the network.
8 Install the PC Card in another functioning PC and run the
tests again.
Your PC may be defective. If the PC Card passes the tests in
the second PC, contact the reseller or manufacturer of the
original PC.
9 If you experience problems that occur only when running
under Microsoft Windows, consult the README files that
are provided in Windows.
The README.WRI, NETWORKS.WRI, and SYSTEM.WRI files all
contain information that could be helpful.
ROUBLESHOOTING