BMW 318i Owner's Handbook Manual page 95

5. To program additional original hand-held
transmitters, repeat steps 3 and 4.
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
You can operate the device while the ignition is
switched on.
If the device fails to function even after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To establish this, either
consult the operating instructions for the origi-
nal hand-held transmitter or press the pro-
grammed memory button 1 on the integrated
universal remote control for a longer period. If
the LED 2 on the integrated universal remote
control flashes rapidly for a short while and then
remains lit for about two seconds, the original
hand-held transmitter uses an alternating-code
system. If it uses an alternating-code system,
program the memory buttons 1 as described
under Alternating-code hand-held transmit-
ter.<
Alternating-code hand-held
transmitter
To program the integrated universal remote
control, consult the operating instructions for
the device to be operated. The instructions
should indicate what scope there is for synchro-
nisation.
When programming an alternating-code hand-
held transmitter, the following additional points
should be noted:
Programming will be easier if another per-
son is available to assist
1. Park your car within the range of the radio
remote control device.
2. Program the integrated universal remote
control as described above under Fixed-
code hand-held transmitter.
3. Establish the location of the button on the
receiver of the device to be operated, e.g.
on the drive system.
4. Press the button on the receiver of the
device to be operated. Once step 4 has
Online Edition for Part no. 01 41 0 013 257 - © 02/07 BMW AG
5.
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
Deleting all stored programs
Press the left-hand and right-hand memory
button 1 for approx. 20 seconds until the LED 2
flashes rapidly. All memorised programs are
deleted.
Reassigning individual programs
1.
2.
3.
you.<
been performed, step 5 must be completed
within about 30 seconds.
Press programmed memory button 1 on
the integrated universal remote control
three times.
If you have any queries, please contact
your BMW Service centre.<
Point the original hand-held transmitter at
memory buttons 1 at a distance of approx.
10 to 30 cm, approx. 4 to 12 in.
The required distance between the
hand-held transmitter and memory
buttons 1 depends on the system of the
particular original hand-held
Press the desired memory button 1 on the
integrated universal remote control.
If the LED 2 flashes slowly after approx.
20 seconds, press the command button of
the original hand-held transmitter. When
the LED 2 starts to flash rapidly, release
both buttons. If the LED 2 does not start to
flash rapidly after approx. 15 seconds,
change the distance and repeat the step.
transmitter.<
93