Backlight Setting; Warm Boot / Cold Boot - Unitech PA970 User Manual

Backlight Setting

Because the power consumption of the LCD backlight is high, turn off the
backlight function if it is not necessary. If a backlight is required, select
the "automatically turn off the back-light" function.
To change backlight settings, select Settings / Control Panel from the Start
menu, and then double tap the Display icon.
Tap the "Backlight" menu item to display the following three selections:
Automatically turn off the backlight when using battery power:
Tap the check box to toggle this function. Available idle times are:
15 and 30 seconds; and 1, 2, and 5 minutes.
Automatically turn off the backlight when using external power:
Tap the check box to toggle this function. Available idle times are:
15 and 30 seconds, and 1, 2, 5, 10, 15, and 30 minutes.
Automatically turn on the backlight when any key is pressed:
This function is activated by the PA970's keypad rather than the Windows
CE keyboard.

Warm Boot / Cold Boot

Warm Boot
• Via Hardware: To perform a warm boot while the PA970 is operating,
insert the end of an unfolded paperclip into the reset hole on the back
of the terminal, right below the SD Card compartment cover.
Via Software: Under the Windows folder of your terminal, locate the file
•
BootMode.exe, execute the program, and confirm the warning message.
WARNING: Warm Boot will cause unsaved data to be lost.
16
PA970 User's Manual