Porter-Cable PCC583B Instruction Manual page 12

90577349 PCC583B Inflator.qxd:??????-00 BDL500 laser
from your vehicle's 12 Volt accessory socket (if used).
• Turn the main power switch to the off (middle) position.
Note: If the main power switch is turned off, all settings will be lost and will need to be re-
entered following the instructions under the heading 'Setting the automatic shut-off
pressure'. This is a safety feature to prevent the risk of items OVER INFLATING.
USING THE INFLATOR AS A PRESSURE GAUGE
• Push the main power switch to the right (inflate position) to power up the LCD (figure H).
• Connect the universal valve adaptor to the item to be checked.
• The LCD will display the item s pressure.
• After checking, turn the main power switch off (middle position) and return the air hose to
the storage location.
OPERATING THE HIGH-VOLUME PUMP
WARNING:
Do not operate the pump when the vehicle s engine is running.
Note: Make sure that your 12 Vdc accessory socket is live. On some vehicles the
accessory socket may only become live when the ignition key is in the accessory position.
To inflate using the high-volume pump (i.e air mattresses, rafts, swimming pool
floats):
Note: The pump mode DOES NOT have an auto shut-off feature.
• Remove the high-volume hose from the storage
compartment on the side of the unit and connect it to
the high-volume pump inflate connection (figure L).
• Insert the hose (with accessories if required) into
the item to be inflated.
• To start the pump, push the main power switch to
the left (pump position) (figure M). The pump will
start immediately and the LCD screeen will not be
illuminated.
• When the item is inflated as required or to stop the
pump at any time return the main power switch to the
off position.
• Remove the hose from the item and store it on the unit.
To deflate using the high-volume pump (i.e air mattresses, rafts, swimming pool
floats):
Note: The pump mode DOES NOT have an auto shut-off feature.
• Remove the high-volume hose from the storage
compartment on the side of the unit and connect it to
the high-volume pump deflate connection (figure N).
• Insert the hose (with accessories if required) into
the item to be deflated.
• To start the pump, push the main power switch to
the left (pump position) (figure O). The pump will
start immediately and the LCD screeen will not be
illuminated.
• When the item is deflated or to stop the pump at
any time return the main power switch to the off
position.
• Remove the hose from the item and store it on the unit.
REPLACING THE FUSE IN THE VEHICLE DC ACCESSORY PLUG
• Remove the cap by turning it counterclockwise.
• Remove the center pin.
• Remove the fuse.
• Insert a new fuse of the same type and size (8A/250V).
• Replace the cap and center pin.
• Tighten the cap by turning clockwise onto the plug.
7/22/11 3:07 PM
L
M
N
O
12
Page 12