Porter-Cable PCC583B Instruction Manual page 10

90577349 PCC583B Inflator.qxd:??????-00 BDL500 laser
FITTING THE ACCESSORIES - FIGURE E
Your inflator is supplied with the standard tapered nozzles and the needle inflator
nozzle (stored in the back of the handle).
• To use the universal valve adaptor, make sure that
the lever is in the up position.
• Place the valve adapter over the stem of the
inflation needle or tapered nozzle (figure E).
• Press the lever on the valve adapter down to lock it
in place.
• Place the inflation needle or tapered nozzle into the
item to be inflated.
Note: Always make sure that the lever is in the up
position when not in use. Operate your inflator only
with the universal valve adaptor or with the included
nozzles.
Note: Make sure that the universal valve adapter is
firmly locked in place before turning the inflator on.
High Volume Hose - Figure F
• To use the high volume hose, remove it from the
side storage location.
• Use the hose with the tapered nozzle for small
openings or without the nozzle for large openings.
Many inflatables have an internal flap that prevents
air loss during inflation, especially air mattresses.
Unless this flap is displaced by the nozzle the
inflatable will not inflate. Push the nozzle firmly into
the valve to make sure that you push this flap out of
the way.
WARNING:
Risk of Bursting. Excessive air pressure may cause a hazardous risk of
bursting or personal injury. Check the manufacturer's maximum pressure rating for items
being inflated.
Note: If the pressure rating for the item being inflated is above 100 psi, note that the
maximum run time is 10 minutes, leave to rest for 20 minutes before re-use.
WARNING:
Do not operate the inflator when the vehicle s engine is running.
Note: Make sure that your 12 Volt accessory socket is live. On some vehicles the
accessory socket may only become live when the ignition key is in the accessory position.
To power the display from the 12Vdc adapter:
• Always fully extend the 12 Vdc cord before each use (figure G).
• Insert the 12 Vdc adapter into your vehicles 12 V accessory socket.
• Push the main power switch to the right (inflate position) to power up the LCD (figure H).
G
OPERATING THE INFLATOR
10
7/22/11 3:06 PM Page 10
E
F
H