Settings Tab - Lincoln Electric POWER WAVE MANAGER IM8002 Operator's Manual

Observer
Field Description
Average amps
Hundreds of times per second, the Welding Power Source takes a measurement of
the arc current being used while the welder is active for this weld. When the weld
is complete, the power source averages those measurements together. The
Average amps column displays that average value for this weld.
Average volts
Hundreds of times per second, the Welding Power Source takes a measurement of
the arc voltage being used while the welder is active for this weld. When the weld
is complete, the power source averages those measurements together. The
Average volts column displays that average arc voltage value for this weld.

Settings Tab

The Settings tab allows you to identify which weld sequencer states are modified when you change
a welding setting on the Charts tab (such as Workpoint or Trim). Place a check mark next to the
appropriate states.
NOTE |
If you want to control the machine's output from within Power Wave® Manager, place a check mark next to
the Show Output ON/OFF button option. This displays a button in the toolbar allowing you to turn the
output of the Welding Power Source on or off. For safety, you must press and hold the Ctrl key on the
keyboard while clicking the button in order for it to turn the power source on or off.
STOP |
IM8002
In order to see a parameter in the charts for the weld, you
must choose the signal before you begin welding. Adding
the signal after completing the weld does not create any
data to display.
Figure 9.10 Settings Tab
Use extreme caution when controlling the output from
Power Wave® Manager. The output does not automatically
shut off if you change screens or exit Power Wave®
Manager.
Power Wave® Manager User Manual
Chapter 9. Tools
9.11