Feeder Settings
Diagnostics Tab
You can use the Diagnostics tab to troubleshoot and verify the operational state of your wire feeder. If you
have multiple wire feeders connected to this welding power source, you can select the wire feeder from
the Select Wire Feeder module drop-down at the top of the window (Figure 8.1 on page 8.1).
STOP |
IM8002
Buttons on this tab control the wire feeder
powered by the Welding Power Source. Be sure
to exercise all appropriate safety procedures when
performing actions on this tab.
Figure 8.3
Power Wave® Manager User Manual
Diagnostics Tab
Chapter 8. Wire Feeder
8.3