Identifying Monitor Conditions - HP LE1851wl User Manual

Identifying Monitor Conditions

Special messages will appear on the monitor screen when identifying the following monitor conditions:
Input Signal Out of Range—Change resolution setting to 1366 x 768 – 60Hz—
●
Indicates the monitor does not support the input signal because the resolution and/or refresh rate
are set higher than the monitor supports (LE1851w and LE1851wl models).
Input Signal Out of Range—Change resolution setting to 1600 x 900 – 60Hz—
●
Indicates the monitor does not support the input signal because the resolution and/or refresh rate
are set higher than the monitor supports (LE2001wm, LE2001w, and LE2001wl models).
No Source Signal—Indicates the monitor is not receiving a video signal from the PC on the
●
monitor video input connector. Check to determine if the PC or input signal source is off or in the
power saving mode.
Auto Adjustment in Progress—Indicates the auto-adjustment function is active.
●
Monitor Going to Sleep—Indicates the screen display is entering a sleep mode.
●
Check Video Cable—Indicates the video cable is not properly connected to the computer.
●
OSD Lockout—The OSD can be enabled or disabled by pressing and holding the
●
on the front panel for 10 seconds. If the OSD is locked, the warning message OSD Lockout
displays for ten seconds.
If the OSD is locked, press and hold the
◦
If the OSD is unlocked, press and hold the
◦
Power Button Lockout—Indicates the power button is locked. If the power button is locked,
●
the warning message Power Button Lockout displays.
If the power button is locked, press and hold the power button for 10 seconds to unlock the
◦
power button function.
If the power button is unlocked, press and hold the power button for 10 seconds to lock out
◦
the power button function.
Theft Mode Enabled—Indicates that theft deterrence mode has been activated. Theft
●
deterrence is an optional feature that can be set up in HP Display Assistant. Theft deterrence mode
is triggered if both the power and display cables have been disconnected from the monitor, the
monitor is reconnected to a different computer, and the theft deterrence PIN number is not entered
within the elapsed time. When the monitor is in theft deterrence mode, all front panel buttons are
disabled other than the power button.
Speaker Self-Test In Progress—Indicates the monitor is testing the left and right speakers.
●
ENWW
Menu button for 10 seconds to unlock the OSD.
Menu button for 10 seconds to lock the OSD.
Identifying Monitor Conditions
Menu button
25