Installing The Belt Hook; Using Non-Marring Tips - Bostitch GF28WW Operation And Maintenance Manual

Always disconnect fuel and battery before making adjustments or before attempting any
part assembly or disassembly.
Hook can be used on either side of the tool. To remove, replace or switch belt hook side, see Fig. 1 & 3.
1. Remove the fuel cell and battery from the tool.
2. Hook is held in by a screw and a hook plate. (Fig. 2)
1
Always disconnect fuel and battery before making adjustments or before attempting any
part assembly or disassembly.
The contact arm and nose will become hot after prolonged or rapid use. DO NOT TOUCH
with BARE HANDS, allow to cool or use gloves when adjusting a tool that is hot.
The no-mar tips are used to prevent scratches to the work surface. Use the following steps to install the no-
mar tip to the contact arm:
1. Remove the fuel cell and battery from the tool.
2. Remove no-mar tip from storage compartment located on the reverse side of the magazine. (Fig. 6 &7)
3. Install no-mar tip on contact arm, note markings to indicate the exit location of the nail to help with proper
positioning. (Fig. 4 & 5)
4. When not in use, no-mar tip can be returned to storage location.
4
No-Mar Tip
2
6
No-Mar Tip
2
USING THE NON-MARRING FINISH TIPS
Contact Arm
Magazine

INSTALLING THE BELT HOOK

3
5
Contact Arm
No-Mar Tip
7
No-Mar
Tip
Magazine
-15-