Installing The Fuel Cell - Bostitch GF28WW Operation And Maintenance Manual

INSTALLING FUEL CELLS
FUEL CELL CONTENTS EXTREMELY FLAMMABLE. Do not incinerate even when empty.
FUEL CELL CONTENTS UNDER PRESSURE: Keep away from temperatures over 120˚F (50˚C).
Keep out of sun. Store at room temperature (68°-80°F / 20°-27°C).
KEEP OUT OF THE REACH OF CHILDREN.
MAY FORM FLAMMABLE/EXPLOSIVE VAPOR-AIR MIXTURE: Do not use near flames or
spray on heated surfaces. Keep away from ignition sources. Use only outside or in well
ventilated rooms. Keep container in well ventilated place.
No Smoking when handling fuel cells.
IRRITANT - KEEP AWAY FROM SKIN AND EYES. NOT FOR HUMAN CONSUMPTION.
VAPOR HARMFUL - DO NOT INHALE GAS
Do not puncture or attempt to open the gas cartridge, it is non-refillable.
1. Install metering valve on fuel cell (see directions on Preparing the Fuel Cell located on page 9 and printed
directly on fuel cell).
2. Unlatch the fuel cell cover (actuator) at top of tool. (Fig. 1A for Finish Tools, Fig. 1B for Framing Tools)
3. Insert fuel cell into the nailer (Fig. 2). Be sure to use proper fuel cell for your model, see chart on page 7.
4. Insert stem of fuel cell into adapter (Fig. 3 & 4).
5. If adapter becomes loose, reinsert into hole in tool body (Fig. 5).
6. Close fuel cell cover (actuator). (Fig. 6A for Finish Tools, Fig. 6B for Framing Tools)
1A
2. Pull out
3
Adapter
5
Insert into the hole
1B
1. Push up
Stem
Fuel cell
6A
Adapter
Latch
Cell cover
4
2. Push down
1. Swing back
-10-
2
Fuel cell
Stem
Adapter
6B
Cell cover
Fuel cell