Cisco EXPLORER 2100 Installation Manual page 15

Optional Devices,
VCR
OUT TO IN FROM
TV ANT.
6
MODEL E2051-X01
TO
TV
CABLE
OUT
CABLE
FROM
IN
VCR
5
BYPASS
Bypass Module Attached to
EXPLORER DHCT
5 Align the mounting tabs with the screw holes.
Tighten the screws; do not overtighten.
6 Connect to your TV and VCR.
7 Connect your cable input from the wall.
8 Connect any additional devices, if applicable.
9 Do you have other devices to connect?
• If yes, see page 9 to locate other
connection diagrams appropriate for
your system.
• If no, plug in the power cord to an AC
power outlet.
continued
TV
Cable Input
CABLE/
From Wall
ANTENNA
7
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CABLE
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO
INPUT
RECEIVE OVER-THE-AIR BROADCAST
120 VAC 120 VAC
SIGNALS. CONNECTION OF THIS DEVICE
IN ANY OTHER FASHION MAY CAUSE
60Hz 5A 60Hz 40W
HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN VIOLATION
OF THE FCC RULES, PART 15.
Activating and Deactivating RF Bypass
If your remote control includes a Bypass key, follow these
instructions to use the Bypass feature.
To activate the Bypass feature, press the Bypass key. The Bypass
indicator illuminates on the DHCT.
Notes:
• You can only view analog channels; digital channels are not
available while the Bypass feature is active. (Verify with your
cable service provider which channels are analog and which
channels are digital.)
• Use the Bypass key to toggle the feature on and off .
To deactivate the Bypass feature:
1. Press the Bypass key on the remote control. The Bypass
indicator no longer illuminates on the Explorer DHCT.
2. Tune your TV using one of the following methods:
• If the TV/VCR switch on your VCR is in the VCR position, you
must tune your TV to the VCR output channel (channel 3 or 4).
You can view a tape, or you can view the channel to which
the Explorer DHCT is tuned.
• If the TV/VCR switch on your VCR is in the TV position, you
must tune your TV to the Explorer DHCT's output channel
(channel 3 or 4). You can only view programs from the
Explorer DHCT, regardless of what your VCR is playing.
15