Edit Program - Elation Professional Design Beam 1200C User Manual

This function allows a user to make small adjustments to the effect wheels (color,
gobo, shutter, etc) to compensate for ware or in the event a sensor has been knocked
slightly out of place. Because improper use of this function can result in undesired
operation this function has been password protected. The password is 050 and must
be entered each time the calibration menu function is entered.
10.7 USER MODE:
allowing the fixture to match the channel order of other fixtures on the market for
easier operation. A total of three user modes may be configured: User Mode A, User
Mode B, and User Mode C.

10.8 EDIT PROGRAM:

10.8.1 Select program – This function allows the user to select one of ten of the user
defined built-in programs. This program is then accessed in "Function Mode" under
"Program Run."
10.8.2 Edit program – This function allows the user to edit the built-in programs.
10.7.1 Edit Scenes – This function allows the user to edit or define the actual scenes that
are stored in the user defined built-in programs that are accessed in the previous
step.
10.7.2 Auto Scenes Rec - The Design Beam 1200C features an integrated DMX recorder
by pre-programmed scenes can be transmitted to the fixture via any standard DMX
controller. This function allows those scenes to be stored in to the fixture's built-in
memory and then subsequently used to create user-defined programs. See working
with built-in programs Section 14 / Page 39.
©Elation Professional®
This function allows the user to create user defined channel orders
32 Design Beam 1200C™
Design Beam 1200C™