Login Through The Pc's Com Port (If Required, See Note) - Quintum Tenor AF Product Manual

Chapter 3: Installation

Login through the PC's COM port (if required, see note)

NOTE:
If you do have a COM port on your PC, when you log into a unit through the COM port at bootup,
you have the option either to restore factory defaults or to configure the static IP address in the
Tenor. The instructions which follow are for configuring a static IP address.
Connect through the COM port as follows:
1. Click on Start > Programs > Accessories > Communications > HyperTerminal. The Connection
Description window is displayed.
2. Enter a connection name (i.e., name for the unit such as Tenor AF NJ). Click OK.
3. Choose the serial port on your PC from the Connect Using drop down list box (i.e., Direct to
Com 1). Click OK. The COM1 Properties window is displayed. See
4. Select the following information:
• Bits per Second: 38400
• Data Bits: 8
• Parity: None
• Stop bits: 1
P/N 480-0084-00-12
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
This step is only necessary if you wish to set a static IP address.
Figure 3-8 COM1 Properties Window
Figure 3-8.
3-10