Troubleshooting - Cateye Stealth 10 CC-GL10 Instruction Manual

Troubleshooting

The following troubles are not due to failure.
See also "FAQ" in CATEYE Atlas™ (web) (http://www.cateyeatlas.com/qa/).
Trouble Check Items
When the power is
turned on, (bat-
tery icon) flashes, and –
then no display ap-
pears.
The power is turned off
while riding.
–
No display appears by Is the battery for the com-
pressing and holding puter empty?
the button for 2 sec-
onds.
Incorrect data appear.
–
Measurement cannot Is it immediately after
be performed turning on the power?
( flashes on the
display).
Is it out of the GPS service
area?
Is the weather not suitable
for receiving GPS signal?
Is the unit installed so that
the computer display (an-
tenna) faces to the sky?
Remedy
Remaining battery capacity is
nearly zero.
Charge the computer according to
the procedure in "How to charge"
(page 5).
The power is turned off automati-
cally in 10 minutes without GPS
signal received.
(Auto power off)
Charge the computer according to
the procedure in "How to charge"
(page 5).
Follow the procedure in "When the
operation is unstable" (page 25).
It may take about 2 to 3 minutes to
acquire the positional information
after receiving GPS signal.
GPS signal does not reach, thus
cannot be received in a tunnel and
underground, between high-rise
buildings, under an elevated struc-
ture, etc.
GPS signal may not be received
when it is raining or snowing.
To receive GPS signal effectively,
install the unit so that the computer
display faces to the sky.
Trouble Check Items
The measurement data
is wrong.
–
MEM FULL flashes. Does the maximum re-
cording time or the num-
ber of trips exceed the
upper limit?
* For details, see "Record
interval and capacity
limit" (page 16)
Does the maximum time
for one trip exceed the up-
per limit?
* For details, see "Record
interval and capacity
limit" (page 16)
The backlight does not Are the start time and end
light up even at the time set to the same hour?
preset hour.
The backlight lights up Is the start time of the
during the daytime. night-time set correctly?
Remedy
Measurement may stop, or the
measurements may differ from the
actual value depending on the GPS
receiving status, since this unit
measures using GPS signal.
Connect the computer to your PC
to upload the trip data (page 13).
All the trip data transferred to your
PC will be deleted from the com-
puter, and new data will be able to
be recorded.
Perform the resetting operation
(page 10) to stop the current trip.
Then, you can record as another
trip.
The backlight does not light up
when the start time and end time
are set to the same hour.
For information on how to set the
start/end time, see "Changing the
computer configuration" (page 20).
For information on how to set the
start time, see "Changing the com-
puter configuration" (page 20).
26