Functional Description; Important Safety Instructions For Battery Chargers - Porter-Cable Clampsaw PCC475 Instruction Manual

• The label on your tool may include the following symbols. The symbols and their
Symbols
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)

FUNCTIONAL DESCRIPTION

1. On/off switch
Figure A
2. Lock-off button
3. Pivot release slider
4. Shoe
5. LED Work light
6. Adjusting shoe
7. Shoe adjustment
button
8. Blade clamp collar
9. Battery
10. Battery release button
11. Charger
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.
Recommended Minimum Wire Size for Extension Cords
25 ft.
Total Length of Cord
7.6 m 15.2 m
18
Wire Size AWG
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGERS

battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using battery pack.
Shock hazard. Do not allow any liquid to get inside charger.
WARNING:
50 ft. 75 ft.
22.9 m
18 16
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
..................earthing terminal
................safety alert symbol
.../mi n orrpm/spm..strokes or reciprocation
A
3
1
9
10
11
100 ft. 125 ft.
30.5 m 38.1 m
16 14
5
per minute
7
2
150 ft. 175 ft.
45.7 m 53.3 m
14
6
8
4
5
12