Connecting The Speakers - Adam Tensor Beta Operation Manual

4. Connecting the speakers

After having unpacked and set up your loudspeakers, please allow the system
to acclimate to the temperature of the room. Please do not connect the
speaker for approximately an hour.
Before connecting the loudspeakers to your audio components and the power
source make sure that both the loudspeakers and your audio system is switched
off!
a) Use the provided Speakon-cables to connect the bass units with the upper units.
After you have plugged it in turn the plug to the right until it locks.
b)
Connect the loudspeakers with your audio components using one XLR cable per
loudspeaker. The male plug goes into the loudspeaker, the female plug into your
audio component.
We recommend using high quality cables to guarantee optimal performance.
c)
Check if the specified voltage matches the voltage of the power supply you use.
If this is not the case do not connect the loudspeakers to a power source! Please
contact your local dealer or national distributor.
If the voltages match, connect the loudspeaker via the included power cables to
two AC sockets.
d)
Switch on the main on/off switches on the rear panel of the loudspeakers. The
ADAM logo begins to glow. Now, switch on the standby switch, located to the right
of the logo at the front. The writing 'ADAM TENSOR' will begin to glow and the 'OL'
(overload) indicator will flash a few times.
e)
Make sure that the line out level (volume) of your stereo is either at a low level or
all the way off. Then, switch on your audio system.
f)
Turn on your source of music and adjust the volume carefully.
Please note that the loudspeakers will need a few days to achieve optimum sonic
performance.
Tensor Beta (Active Version) Manual / english
9