Table of Contents
Advertisement
2. Quick Start
2.1
Important Information for set up
After having unpacked your loudspeakers, please allow the system to acclimate
to the temperature of the room for approximately an hour.
We recommend using high quality cables to guarantee optimal performance.
It is important to ensure the speakers stand firmly on a solid surface!
We recommend retaining the original packaging, as it is the best way to
guarantee safe transportation should the need to do so arise.
Please note that the loudspeakers will take some break-in time to achieve
optimum sonic performance.
2.2
Connecting the speakers
a)
Before connecting the loudspeakers to your audio components and the power
source make sure that both the loudspeakers and your audio source are switched
off and set the level controls fully counterclockwise.
b)
Connect the loudspeakers with your audio source by using XLR cables. The male
plug goes into the loudspeaker, the female plug into your audio component.
c)
Check if the specified voltage matches the voltage of the power supply you use.
If this is not the case do not connect the loudspeakers to a power source! Please
contact your local dealer or national distributor.
If the voltages match, use the included power cables to connect the loudspeaker
to the AC sockets.
d)
Switch on the main on/off switches on the back panel of the loudspeakers.
e)
Make sure that the line out level (volume) of your stereo is either at a low level or
all the way off. Then, switch on your audio system.
f)
Switch on the Standby switch on the front panel of your MP1.
g)
Turn on your source of music and adjust the volume carefully.
6
Advertisement
Table of Contents
