To Program Additional Transmitters; Function Setting Chart - Code Alarm CA 510 Owner's Manual

TO PROGRAM ADDITIONAL TRANSMITTERS:

1) Enter the vehicle, and turn the ignition switch to the on position.
2) Press and release the valet push button switch 3 times.
3) The dash mounted LED will flash 1x, and the siren will chirp 1x,
indicating that the system is ready to accept programming of channel #1
which is lock.
4) Press and hold the lock symbol button of the transmitter you wish to
program for 4 seconds or until a long chirp is heard from the siren.
"Repeat step 4 for each transmitter you wish to program"
5) Press and release the valet push button switch one time to advance to
channel 2. The siren will chirp 2 times and the dash mounted LED will Flash
2 times, indicating that the unit is ready to accept programming for channel
# 2 which is only used for unlock
6) Press and hold the unlock symbol button of the transmitter you wish to
program for 4 seconds or until a long chirp is heard from the siren.
"Repeat step 6 for each transmitter you wish to program"
7) Press and release the valet push button switch one time to advance to
channel 3. The siren will chirp 3 times and the dash mounted LED will Flash
3 times, indicating that the unit is ready to accept programming for channel
# 3 which is only used for Remote Start
8) Press and hold both buttons of the transmitter you wish to program for
4 seconds or until a long chirp is heard from the siren.
"Repeat step 8 for each transmitter you wish to program"
Note: This unit will hold up to 4 transmitters
5 Min o
Run Time
1 Sec/1 Sec o
Door Lock Timer
Pulse o
Lights

FUNCTION SETTING CHART

To be completed by installer
10 Min o 15 Min o
3.5 o 1 Sec/Dbl 1 Sec o
ON o
20 Min o
128-6503
3 of 2