Table of Contents
Advertisement
WIDEBAND IR (30KHz---60KHz) INTRODUCTION
IR BLASTER (TX):
To control the source: Plug IR Blaster into IR TX port of transmitter unit. Place blaster in front of the IR eye of the source.
IR RECEIVER (RX):
To control the source: Plug IR Receiver into IR RX port of receiver unit. Place receiver at or near display.
DETAIL DESCRIPTION OF DISPLAY MODES
The quad multi-viewer has (3) display modes.
MODE 1
MODE1:
The quad multi-viewer divides the (4) HD inputs into the same size displays on (1) screen. Switch the inputs using the buttons on
the front panel or IR remote, and the HDMI output audio will correspond to the selected input source.
MODE2:
The quad multi-viewer divides the (4) HD inputs into (1) large and (3) smaller picture displays on (1) screen. Switch the inputs using
the buttons on front panel or IR remote, and the bigger picture will correspond to the selected input source. The HDMI output audio follow
the bigger picture source.
MODE3:
The quad multi-viewer will separate and display the (4) HD inputs individually and become a seamless switcher.
CONNECT AND OPERATE
MODE 2
6
MODE 3
Advertisement
Table of Contents
