N.height Adjustable Armrests; O.armrest Receiver Attachment Clamp; Footrest Height Adjustment; Q.back Adjustments - Quickie GT Owner's Manual

E NG LIS H
N. HEIGHT-ADJUSTABLE ARMRESTS (Option)
1. Installation
a. Slide the outer armpost into the receiver mounted to
the wheelchair frame.
b. The armrest will automatically lock into place.
2. Height Adjustment
a. Rotate height release lever to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push down on arm pad until upper armpost locks
firmly into place.
3. Removing Armrest
a. Press on release lever to unlock and remove the armrest.
O. ARMREST RECEIVER ATTACHMENT CLAMP
Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
1. Loosen the four receiver adjustment bolts (A) on the sides of the receiver.
2. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
3. Tighten the four bolts (A).
Position Adjustment
1. Loosen the three clamp bolts (C) until clamp (B) is loose.
2. Slide armrest receiver to desired position along the chair frame.
3. Tighten all 3 bolts to 212 in.-lbs. (24Nm).
P.

FOOTREST HEIGHT ADJUSTMENT

To adjust the height of your footrest, loosen the screw (D) on both footrest clamps. Slide the footrest up or
down to the new desired height and tighten the two set screws. Use a torque setting of 144 in-lbs (16.3 Nm). It
is recommended that you maintain a minimum of 2.0 inches (5 cm) between the lowest point on the footrest
and the floor. This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.
Q. BACK ADJUSTMENTS
CAUTION – When changing the back angle of the wheelchair both the left and right angle adjustable back
bracket must be in the same hole position before the wheelchair is to be used.
Adjusting Backrest Options
The backrest bracket has two positions, 1 or 2, that can be achieved by removing bolt (E) and pivoting the
bracket forward or rearward. With the bracket in the desired position, reinsert and tighten the bolt. Then follow
the instructions for "Folding and Unfolding the Backrest".
1= Forward Mount. 2= Rearward Mount
MK-100067 Rev. B
45
47
48
46
22
B
A
C
D
1
- 3°
E
+ 7°
+ 17°
2
- 8°
+ 2°
+ 12°
45
46
47
48