Padded Swing-Away Armrests; Height Adjustable Armrests; Back Angle Performance; Cushion Installation - Quickie GT Owner's Manual

E NG LIS H
I. PADDED SWING-AWAY ARMRESTS (Optional)
Swing-away armrests can be detached, or can swing away to allow lateral transfers.
The Swing-away armrests are installed by sliding armrest (A) into receiver (B) on back frame, and aligning the
detent button with the hole in the receiver making sure that the button pops out and armrest is locked.
J. HEIGHT-ADJUSTABLE ARMRESTS (Optional)
1. Installation
a. Slide the outer armpost into the receiver mounted to the wheelchair frame.
b. The armrest will lock into place if pressed down firmly.
2. Height Adjustment
a. Rotate height release lever (2) to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad (4) down until upper armpost locks firmly into place.
3. Removing Armrest
a. Push on the release lever (3) and remove the armrest.
K. BACK ANGLE PERFORMANCE
Folding and Unfolding the Backrest
1. Release the backrest by pulling the release cord (C) with a simple, short force.
2. While maintaining tension on the release cord, rotate the backrest to the desired angle or to the fold-
ed down position.
3. Lock the backrest in place by releasing the cord and allowing the pins (D) to engage in the nearest
hole (E) of the backrest bracket (F).
Be sure the pins (D) are fully engaged through the backrest bracket (F) on both sides of the chair.
Test the backrest to be sure it is locked before use.
L.

CUSHION INSTALLATION

Place cushion on seat sling with VELCRO® side down. The beveled edge of the cushion should be in front.
Press firmly into place.
M. STORAGE TIPS
1. Store your chair in a clean, dry area. If you fail to do so, parts may rust or corrode.
2. Before using your chair, make sure it is in proper working order.
3. Inspect and service all items on the "Maintenance Chart".
4. If stored for more than three months, have your chair inspected by an authorized supplier before use.
N. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was properly
prepared.
2. Review the troubleshooting chart at the beginning of this section.
3. If your problem persists, contact your authorized supplier. If you still have a problem after contacting
your authorized supplier, contact Sunrise customer service. See the introduction page for details on how
to contact your authorized supplier or Sunrise customer service.
MK-100067 Rev. B
16
17
18 19
WARNING
16
16
A
B
4
17
6
5
2
1
3
8
7
1. Outer armpost
2. Height Release Lever
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Receiver
8. Clamp
18
D
C
F
E
E
19