Standard Anti-Tip Tubes; Anti Tip Swing-Away; Gt With Xtr Suspension Anti-Tip Tubes; M.padded Swing-Away Armrests - Quickie GT Owner's Manual

E NG LIS H
3. 3-D Perpendicular Alignment
The allen bolt adjustment (A) provides another dimension of adjustability in addition to the spline system. The
bolt may be loosened to relieve tension in the stem assembly (B). The caster angle may then be fine-tuned and
the bolt retightened.
J.

STANDARD ANTI-TIP TUBES

Sunrise Medical recommends anti-tip tubes for all wheelchairs.
Use torque setting of 106 in-lbs. (12 Nm) when installing anti-tip tubes.
K. ANTI-TIP SWING AWAY
1. Swing-Away Anti-Tip
The anti-tip wheel may have to be raised or lowered to achieve proper clearance of 1 1/2" to 2".
To adjust, using an Allen key and wrench, remove bolt (C) from current position. Adjust to proper height, rein-
sert bolt, and tighten back into place.
L. GT WITH XTR SUSPENSION ANTI-TIP TUBES (Option)
Sunrise Medical recommends anti-tip tubes for all wheelchairs.
NOTE– Use torque setting of 100 in./lbs. when setting-up anti-tip tubes.
1. Adjusting Anti-tip Receiver
a. Remove anti-tip tubes (D) from anti-tip receivers (E).
b. Remove button head bolt (F) from anti-tip tube receiver.
c. Reposition bracket to desired height.
d. Reinsert button-head bolt and tighten.
e. Repeat with second anti-tip tube receiver. Both brackets should be at exactly the same height.
M. PADDED SWING-AWAY ARMRESTS (Option)
Swing-away armrests can be detached or can swing away to allow lateral transfers.
They are height adjustable (2") by moving bolts (G) up or down in predrilled holes on
armrest bracket.
Swing-away, removable armrests are installed by sliding armrest into receiver (H) on back frame.
Swing-away, angle adjustable
To change the angle, remove bolts (I), reposition to needed angle. Reinsert bolt and tighten.
40
41
44
42 43
21
40
A
B
C
42
D
F
E
43
D
E
F
G
H
I
MK-100067 Rev. B
41
44