Table of Contents
Advertisement
Alternatively the unit may also be powered down by momentarily
pressing the rocker-switch on the front panel.
It will take up to one minute before the lights go off and it is then safe
to unplug the SBS.
VII.
Setup – Step 5: Check Email Settings
Please ensure that the email clients on connected computers are
using authenticated SMTP for outgoing email (See Section 3.3 of the
Owner's Handbook).
VIII. Setup – Step 6: Configure All Uplinks
Configure any additional uplinks as required (See sections IX and X
below). Ensure that the Inactivity Timeout is set to the desired level
for each uplink device (See Section 4.2 of the Owner' Handbook).
The installation is now complete and should be carefully tested.
The main sections of the Owner's Handbook should now be
used as the reference for operating the SBS.
IX.
Viewing and Editing an Uplink Connection
You can view and/or edit the uplink settings through the User
Interface as follows:
1.
Click on the "SETTINGS" tab and then the "UPLINK" tab.
2.
From the "Edit connection" drop-down menu select the uplink
connection that you wish to view or edit.
Advertisement
Table of Contents
