Table of Contents
Advertisement
VI.
Setup – Step 4: Connect the TVRO
Connect the TVRO as follows:
1.
Connect the cable from the TVRO antenna to the f-type
connector labelled "LNB IN" on the back of the SBS.
2.
Make sure that the TVRO antenna controller is locked on the
satellite.
3.
On the CONNECT page of the SBS User Interface, select the
satellite you are using from the "Downlink" options (drop-down
menu).
4.
Select the uplink you wish to use from the "Uplink" options
(drop-down menu).
5.
Click once on the "CONNECT" button on the right of the
Service Status Diagram.
When all three arrows are
highlighted in dark blue on
the Service Status Diagram
the Wired Ocean connection
is up and running and you
can access the internet. To
disconnect, click once on
the "DISCONNECT" button
on the right of the Service
Status Diagram.
If the second or third arrows do not highlight as above please refer to
Sections 5.3 and/or 5.4 of the Owner's Handbook.
The SBS is designed to stay running continuously. Should you need
to turn it off you can use the "SHUT DOWN" command in the SBS's
User Interface:
1.
Open the SBS User Interface (see 2.2 below).
2.
Click on the "SETTINGS" tab and then the "GENERAL" tab.
3.
Click once on the "SHUT DOWN" button at the bottom of the
page.
Advertisement
Table of Contents
