Connecting Other External Audio Sources; Switching The External Audio Source On/Off And Selecting It; Naming External Audio Sources (Aux Edit) - Blaupunkt Hamburg MP68 Operating And Installation Instructions

Connecting other external audio
sources
If no C'n'C Blaupunkt accessory device and
no CD changer is connected to the device,
you can connect other external audio sources
via the rear AUX input, such as portable CD
players, MiniDisc players or MP3 players.
Note:
An adapter cable is needed to connect
an external audio source via the rear AUX
input. You can obtain this cable (Blau-
punkt no.: 7607897093) from your
Blaupunkt dealer.
If you want to connect such an external au-
dio source, proceed as follows:
Note
The first step is omitted if the current
software of this device does not yet offer
any C'n'C support.
1. Check whether the non-C'n'C mode
is set for the rear AUX input. For fur-
ther details, please read the section
"Adjusting the rear AUX input mode" in
this chapter.
2. Connect the external audio source to
the rear AUX input while the device is
switched off.
3. In the menu of the device, switch on the
external audio source. For further de-
tails, please read the following section,
"Switching the external audio source
on/off and selecting it".
4. If necessary, make additional settings
for the external audio source. For fur-
ther details, please read the additional
sections in this chapter.
AUX mode
Switching the external audio source on/
off and selecting it
If you connected an external audio source
to the rear AUX input, you must activate the
AUX input in the menu. This allows you to se-
lect the external audio source with the SRC
button
0.
.... Press the
MENU
button
0.
.... Press the
<
rocker switch
@
to open
the "Syst ll system menu.
.... Press the rocker switch i\ or
v@
until
the "AUX" menu item is selected.
.... Press the OK button 0 to call up the
menu item.
.... Switch between the settings with the
rocker switch
<
or>
@.
- > "Aux"51: AUX input on.
- <
"AUX"
D:
AUX input off.
.... Press the OK button 0 to select adif-
ferent function, or press the DIS-ESC
button
®
to exit the menu.
Naming external audio sources (AUX
EDIT)
For the rear AUX input, you can enter asepa-
rate name that is shown on the display if you
select the connected audio source.
.... Press the
MENU
button
0.
.... Press the
<
rocker switch
@
to open
the "Syst" system menu.
.... Press the rocker switch
1\
or
v
®
until
the "AUXEDIT" menu item is selected.
.... Press the OK button 0to call up the
menu item.
37