Operation; Before First Time Operation; Checks Before Starting - Ferris 5901244 Operator's Manual

Is600z series zero-turn riding mower
Table of Contents

Advertisement

A
B
C
D
E
Choke: Close the choke for cold starting. Open the choke
once the engine starts. A warm engine may not require choking.
Pull the knob UP to close the choke. Push the knob DOWN to
open the choke.
PTO (Power Take Off) Switch: The PTO switch engages
and disengages the mower. Pull UP on the switch to engage,
and push DOWN to disengage.
Ignition Switch: The ignition switch starts and stops the engine,
it has three positions:
OFF
Stops the engine and shuts off the electrical
system.
RUN
Allows the engine to run and powers the electrical
system.
START
Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN position with
the engine stopped—this drains the battery.
Throttle Control: The throttle controls engine speed. Move the
throttle forward to increase engine speed and back to decrease
engine speed. Always operate at FULL throttle.
Fast throttle speed.
Slow throttle speed.
Hour Meter: The hour meter measures the number of
hours the PTO has been engaged. The hour meter has a self
contained power source so the total hours are always visible.

Operation

Before First Time Operation

• Be sure to read all information in the Safety and Operation
sections before attempting to operate this tractor and
mower.
• Become familiar with all of the controls and how to stop the
unit.
• Drive in an open area without mowing to become
accustomed to the unit.
Choke
PTO Switch
Ignition Switch
Throttle Control
Hour Meter
WARNING
• Never operate on slopes greater than 15°.
• Select slow ground speed before driving onto a slope.
Use extra caution when operating on slopes with a
rear-mounted grass catcher.
• Mow across the face of slopes, not up and down, use
caution when changing direction on slopes and do NOT
start or stop on a slope.
WARNING
• Never allow passengers to ride on the unit.
• Before leaving the operator's position for any reason,
engage the parking brake, disengage the PTO, stop the
engine and remove the key.
• To reduce fire hazard, keep the engine, rider and mower
free of grass, leaves and excess grease. Do NOT stop or
park rider over dry leaves, grass or combustible materials.
• Fuel is highly flammable and must be handled with care.
Never fill the tank when the engine is still hot from recent
operation. Do NOT allow open flame, smoking or matches
in the area. Avoid over-filling and wipe up any spills.
WARNING
Do NOT load this zero-turn rider on a trailer or truck using two
separate ramps. Only use a single ramp that is at least one
foot wider than the width of the rear wheels of this rider. This
rider has a zero turning radius and the rear wheels could fall
off the ramps, or the rider could tip over injuring the operator
or bystanders.

Checks Before Starting

• Check that the crankcase is filled to the full mark on the
crankcase oil fill and dipstick. If necessary, add oil through
the engine oil fill. See the engine Operator's manual for
instructions, engine oil dipstick location and oil
recommendations.
• Make sure all nuts, bolts, screws and pins are in place and
tight.
• Adjust the seat position, and make certain you can reach
all the controls from operator's position.
• Fill the fuel tank with fresh fuel. Refer to engine manual for
fuel recommendations.
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5901256590130959012455901255Is600z series

Table of Contents