Safety Alert Symbol And Signal Words; Safety Interlock System; Features And Controls; Control Functions And Locations - Ferris 5901244 Operator's Manual

Safety Alert Symbol and Signal Words

The safety alert symbol indicates
hazard. A signal word (DANGER, WARNING, or CAUTION) is
used with the alert symbol to designate a degree or level of
hazard seriousness. A safety symbol may be used to represent
the type of hazard. The signal word NOTICE is used to address
practices not related to personal injury.
DANGER indicates a hazard which, if not avoided, will result
in death or serious injury.
WARNING indicates a hazard which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazard which, if not avoided, could
result in minor or moderate injury.
NOTICE indicates an action that could result in damage to the
product.

Safety Interlock System

This unit is equipped with safety interlock switches. These safety
systems are present for your safety, do not attempt to bypass
safety switches, and never tamper with safety devices. Check
their operation regularly.
Operational SAFETY Checks
Test 1 - Engine SHOULD NOT crank if:
• PTO switch is engaged, OR
• Parking brake is not engaged, OR
• Ground speed control levers are not in the NEUTRAL
position.
Warning: Low Overhanging
Obstacles Hazard - Check for
overhead clearances before driving
under any objects. Stay clear. Do NOT
allow roll bar to contact low
overhanging obstacles, such as tree
branches and guide wires. Read and
follow all operating instructions and
warnings in the operator's manual.
Warning: Fire Hazard - Keep children,
open flames and sparks away from the
battery, which could ignite explosive
gases.
Warning: Sulfuric acid can cause
blindness or severe burns - Always
wear safety goggles or a face shield
when working on or near a battery.
Warning: Batteries produce
explosive gases - Read and
understand the Operator's Manual
before using this machine.
Important: Do not discard a battery
in the trash - Contact local authorities
for disposal and/or recycling of
batteries.
a potential personal injury
Test 2 - Engine SHOULD crank if:
• PTO switch is not engaged, AND
• Parking brake is engaged, AND
• Ground speed control levers are locked in the NEUTRAL
position.
Test 3 - Engine should SHUT OFF if:
• Operator rises off seat with PTO engaged, OR
• Operator rises off seat with parking brake disengaged.
• Operator moves ground speed control levers out of their
neutral positions before disengaging parking brake.
Test 4 - Blade Brake Check
Mower blades and mower drive belt should come to a complete
stop within seven (7) seconds after electric PTO switch is turned
off (or operator rises off seat). If mower drive belt does not stop
within seven (7) seconds, see your dealer.
NOTE: Once the engine has stopped, PTO switch must be
turned off, parking brake must be engaged, and the ground
speed control levers must be locked in the NEUTRAL position
after the operator returns to the seat in order to start the engine.
WARNING
If the unit does not pass a safety test, do not operate it. See
your authorized dealer. Under no circumstance should you
attempt to defeat the purpose of safety interlock system.

Features and Controls

Control Functions and Locations

The information below briefly describes the function of individual
controls. Starting, stopping, driving, and mowing require the
combined use of several controls applied in specific sequences.
To learn what combination and sequence of controls to use for
various tasks see the Operation section.
13